VLAND OLED Tail lights Assembly Fit for BMW M3 / 3 Series F30 F35 F80 Sedan 6th Gen 2012-2018, Upgraded Rear Lamp with Dragon Scales DRL, Smoked

Mine did not come with the extra cable needed for pre LCI model for inner and outer assembly to communicate the turn signal. I also noticed the fitting is not perfect so needs some adjustment. I am going to return these as the missing cable and plugs are not easily available.UPDATE: I was able to get the cable and connector from a local automotive parts shop and they worked like a charm. The fitting is still not perfect like OEM and the inner lights pop out due to excess sealant. I had to cut the excess sealant with a sharp blade and still do a lot of pushing and holding while I tighten the nut-bolts. After doing all of that, the lights are now fixed on the car. Will recommend if you are ok to go a bit extra mile to workaround the fitting issue. Not sure if missing cable for pre LCI was my bad luck.

Bought the black version. Installation was difficult for the inner two lights as others have pointed out but trimming the weather stripping/padding did the trick. Once it was installed I discovered that ine of the bulbs was burt out so I contacted the seller for a remedy instead of returning them.Updated review....seller responded and sent out replacement bulbs. Really not a huge issue if the bulb size was listed anywhere on the product or paperwork.Great product if it works for you.

The media could not be loaded. Quality of the tail lights are fire but the foaming around them I didn’t like as much. The craftsmanship could have been better. Had to shave down some of it on both pairs to fit flush. Still better alternative than getting oem for sure

Outside tails on both sides easily went in. However, worked for 3 hours and finally got driver said inside tail (on trunk). It was a combination of one side of the resistor's lead interfering with the trunk sheet metal where I had to reinforce the thin wires and then the plastic taillight "hook" never really being able to interface into the hole in the sheet metal. After the three hours I finally got it to stay in and I started on the passenger inner taillight. After 30 minutes I gave up and when I went to remove the driver side inner tail, it had popped off anyways. I re-installer the OEM BMW taillights with ease in less than 10 minutes. Obviously the accuracy in the design or manufacturing on these taillights is not enough up to par for tight tolerances to be installed. Will try the depo taillights instead.

remember that there will be an extra OBD that will not be plugged in on both sides of the trunk light. everything is the way it should be trust me. good product.

There’s something wrong with these taillights I’ve been working to clip these things in for the past 3 hours. (Trunk lights) the rear lights themselves fit in perfect there’s no problem but the trunk lights is so atrocious and the cabling sucks, hard to fit the trunk panel back in with wires all over