BOJACK 1000 Pcs 25 Values Resistor Kit 1 Ohm-1M Ohm with 5% 1/4W Carbon Film Resistors Assortment

I only needed one resistor, but having multiple available was nice as learning how to solder to them had a bit of a learning curve. Make sure you tin the leads and don't let too much heat soak into the resistor body. I have a bunch of spares now, but they'll be of use in the end. When tested with a multimeter, the resistance was well within tolerance, usually under 3%. It was ever so slightly more expensive to purchase a kit versus a handful of the resistance I needed, but now I'll have some around if I have a future project.

nice selection and like that they are packed and labeled per the value and if you remember you can change the values with series and parallel

I had to do a test requiring few resistors.I came across this set and it was a good decision.These resistors will last you aing time.They are packaged and identified properly.Vonrs with table and color code do you can read the value.They are within 5%I recommend this set.

Inexpensive, adequate for my need at the time. I am old-school, where resistors were commonly 2 watts, 1 watt, and the smallest 1/2 watt. Now with today's miniaturization resistors are more commonly 1/4 watt, as are these. My need was satisfied by 1/4 watt power and these did the trick. I now have plenty of them to continue future experiments.

Good product, but not exceptional.

If you’re doing anything even remotely related to electronics—Arduino builds, ESP32 projects, random breadboard testing, or even fixing that cursed power supply from 2007—this resistor kit is a no-brainer.This BOJACK box is basically a resistor armory, and it’s stocked well. You get 25 common values, all 1% tolerance, from 10 ohms to 1MΩ, and all neatly separated in little labeled zip pouches. So no more sorting through a tangled pile of mystery bands that look like they were stored in a ramen wrapper.Each resistor is 1/4 watt, metal film, and I’ve tested a bunch with my multimeter—accurate within spec, clean leads, no oxide or cheap carbon junk. I’ve already used them for:LED current limiting (hello, 220Ω and 330Ω, my old friends)Divider circuits for analog readsLogic pull-ups and pull-downsSwapping values on a custom audio board for tone testingThey hold up to heat well—I’ve soldered dozens in place without one going crispy. And let’s be real: resistors are like paperclips in a tech workshop—you’ll use 2, then come back a week later needing 8 more.What I Like:Accurate, clean, no fakes—1% metal film means stability in actual circuitsLabeled bags = sanity preserved1000 pieces = you won’t run out mid-prototypeIdeal for students, makers, pros, and people who just hoard components like meWhat Could Be Better:Comes in a bag, not a case—pro tip: grab a small parts organizer if you're OCD like meWould love value markings on the resistors (but hey, that’s what multimeters and color code charts are for)

The packaging is great, everything is labeled properly.

Ever sense I purchased this pack there has been some resistance in my circuits. 10/10