3D Printer Rollers v Slot (13pcs/Pack) Gantry Wheel POM Pulley Ender 3 Bed Wheels 625zz for Creality CR10 Ender 3 pro Artillery Sidewinder x1 Rollers

The media could not be loaded. Replacement for the original rollers on my Ender 5 Pro after more than 4000hrs of prints. Decent packing, look great, perfect fit. After about 6hrs they started to creak like a Styrofoam cooler in the car and leave a white residue on the extrusions. I figured they're just new. After cleaning everything and tweaking the e-nuts the creak would return within 1/2hr and continued to worsen on long prints. This went on for 277hrs of create, clean, configure, and continue. I've done a lot to make this machine quiet and these rollers have completely negated my efforts. The video shows them at varying speeds after a 49min print.UPDATE: After going through my normal list of lubricants I finally found that these rollers love plain old hair clipper oil. Over 150hrs and counting of near silent operation with a cheep and readily available lubricant. This truly is a quality product.

Product worked like a charm! If you dont know what you're doing then you will damage the wheels and get a white residue or wear down the rollers. You have to know and understand how the eccentric nuts work or you will just end up tearing these rollers or any rollers up.

Put these on my Ender 5 plus because the stock wheels were a little worn. They work fine but my only complaint after about 60 hours of printing is that they make some squeaking noise.Imagine roller blades on a brand new wood floor. If I loosen the tension the noise gets a little quieter but I’m worried that may be too loose. Hoping the noise goes away after a little more time.

Highly recommend these replacement guide Wheels on Ender S1. Very good quality in my opinion, would buy again when necessary. Supplier great

pom rollers for ender3 printers

This product seemed nice didn't squeak( because I oiled them very well) but they aren't perfectly round and have causes defects in my prints along the z axis. I changed back and no defects

funciona bien para proyectos de robotica.

Replaced oem wheels on my ender 3 v2 and these are really tight when setting it up to not wobble. Started printing and immediately started screeching. Watched the first couple layers of the print to make it was OK. Came back to white residue on the rail and wheels. Like other reviews, these are not too tight. I tightened it just enough to prevent any wobble but even moving with my hand, it seems too tight. I bought some creality brand wheels and will replace these as soon as I receive them.