Tarot 650 Carbon Fiber 4-Axis Aircraft Fully Folding FPV Drone UAV Quadcopter Frame Kit for DIY Aircraft Helicopter TL65B01

You can tell someone sat down and designed this Thing. And by 'Thing' I mean the frame. For instance, the screws are pressure fitted. They made the holes like .5mm too small for all the screws (or something to that effect). So when you are screwing in plates, you sink them when tightening.

I quickly ran out of room for the Pixhawk 6x controller equipment. I would like to purchase additional center plates as they are not offered as spare parts here. I'll have attempt other avenues to procure them.

Amazon took down the first review because I mentioned size, but the whole problem with the product is that it's not accurate to what they said it would be. There also isn't any good instructions just the photo.

Looks great, is light and sturdy. Thanks!

I like this aircraft, but found it to be a challenge for placing some components. For example, I chose to mount the ESCs close to the power source in the center but there is not enough space between the chassis center plates. I had to experiment with sandwiching them between two battery plates slug just below the gimbal mounting tubes. Make sure to allow for wiring clearance inside the center for when you fold the booms for transport.

Quality is good but I have 2 complaints. 1. No standard 20mm or 30.5mm FC mounting holes. 2. Motor mounts must be manually aligned; There is no key/hole to ensure they're aligned.